DITA and XMetaL Discussion
XMetaL Community Forum › DITA and XMetaL Discussion › TOPLEAF: Blank page added after contents in V7 output
-
jlm05 May 15, 2012 at 7:20 pm
TOPLEAF: Blank page added after contents in V7 output
May 15, 2012 at 7:20 pmParticipants 1Replies 2Last Activity 10 years, 8 months agoWe're still testing generating PDFs using XMetal7 and the updated plugin.
In our stylesheets, none of the page layouts are configured to be double-sided – there are no left/right pages.
In the V7 output, if the table of contents does not have an even number of pages, then an “intenationally-blank” page is being added after the contents and before the next section, the preface.
We didn't see this happening in the V6 output, and looking through our V6 stylesheets I can't seem to find a setting that would do that.
Any ideas as to why this extra page is being added?
Thanks,
Janice
mearly May 15, 2012 at 8:08 pm
Reply to: TOPLEAF: Blank page added after contents in V7 output
May 15, 2012 at 8:08 pmDid you check for a
command in the pre-content of MakeToC or endTOC? In the latest default stylesheet, this command appears in the pre-content of mappings for gloassarylist, appendix, chapter, index, part, toc, endRoman, endToC, and MakeToC. If you remove all of those commands or comment them out, I think that would fix the issue. -
AuthorPosts
- You must be logged in to reply to this topic.