DITA and XMetaL Discussion
XMetaL Community Forum › DITA and XMetaL Discussion › Announcement: DITA 1.2 Configuration Kit Available
-
leo71 March 14, 2012 at 4:02 pm
Reply to: Announcement: DITA 1.2 Configuration Kit Available
March 14, 2012 at 4:02 pmI can understand that you can't support this DITA 1.2 Configuration Kit very much, but I have a few doubts:
– Can I install this if I have XMetal 6.0 Enterprise SP1 (Version#: 6.0.2.070)?
– Maybe because of this, at step 4. of the installation instructions I get:
“Error 1606. Could not access network location “C:Program Files (x86)XMetal 6.0Author.”Leen
Derek Read March 16, 2012 at 3:30 am
Reply to: Announcement: DITA 1.2 Configuration Kit Available
March 16, 2012 at 3:30 amThough we have clients running XMetaL Author Enterprise 6.0 and 6.0 SP1 on Windows 7 64-bit they are not supported on this version of Windows (see the release notes for system requirements — there is a note about 64-bit). The DITA 1.2 Configuration Kit was designed to install on top of XMetaL Author Enterprise 6.0 and 6.0 SP1 and assumes those requirements.
Your best bet may be to install and run all of these using Microsoft's “XP Mode” until our 7.0 release comes out.
-
AuthorPosts
- You must be logged in to reply to this topic.
