Home Forums DITA and XMetaL Discussion Generate Output is failing Reply To: Generate Output is failing

Derek Read

Reply to: Generate Output is failing

This sounds a bit like the issues described here:
https://github.com/dita-ot/dita-ot/issues/2212
https://github.com/dita-ot/dita-ot/issues/1715

I'm not sure what the best resolution will be. If you have a table that has an without @colnum set then I would say adding it might be the easiest solution. Assuming that is the trigger that is the cause for your problem and that it is the same issue. I'm not sure because I can't reproduce the issue.

Or you might try getting XMetaL Author Enterprise 12 to run an older version of the DITA Open Toolkit. But in the tracker above they seem to say that issue affects versions older than 2.2.2, so 2.4 should be OK. If you want to try an older You can do that by changing a parameter in the Other Output Parameters section on the Advanced tab in Tools > Configure Output.

By default XMetaL Author Enterprise 12 is configured to run DITA OT version 2.4 but installs 2.4, 2.2 and 2.0.

To change the version use this parameter:

DITA_OT_DIR  =  %XMETAL_SHARED_ALL%DITA_OT2.4

Or

DITA_OT_DIR  =  %XMETAL_SHARED_ALL%DITA_OT2.2

Or

DITA_OT_DIR  =  %XMETAL_SHARED_ALL%DITA_OT2.0

Reply

Products
Downloads
Support