Home › Forums › DITA and XMetaL Discussion › XMetaL 5.5 EE and Visio SVG problem › Reply To: XMetaL 5.5 EE and Visio SVG problem
Derek Read February 1, 2011 at 10:37 pm
Reply to: XMetaL 5.5 EE and Visio SVG problem
February 1, 2011 at 10:37 pmOpen the SVG file in a text editor and check to see how the SVG tag is marked up. It should have @width and @height values. If there are units other than “in” or “cm” specified (no units is also OK as that defaults to pixels) then XMetaL is unable to convert them to an onscreen size in pixels and falls back to 200 x 200px.
I have a script that addresses this that you can install. It adds support for “px”, “pc”, “pt”, and “mm” units. However, we're planning on including the same thing in our next update which is out soon so it might make sense to just hold off and get the update.
