Pages: 1
Print
Author Topic: Output failed when building PDFs  (Read 2448 times)
rde
Member

Posts: 8


« on: September 09, 2011, 01:53:10 PM »

I'm using XMetaL Author Enterprise Version#: 6.0.1.030

XMetaL had been beautifully outputting PDFs for me in three languages (en, jp, and cn) until a couple of weeks ago when I didn't need to do any doc builds for a while. Today I tried building a set of DITA files that I have built many times before--files I have not changed since I last built successfully--and I got a build failed error (see attached image).

I have five sets of DITA documentation that I regularly build PDFs from with XMetal, and none of these are working now. None of the DITA files in any of those projects have changes since I last built successfully. I have not tweaked any files in the DITA_OT folder since I last built successfully. I did install a content management system from SDL Trisoft that uses XMetal, but that installation occurred almost two months ago and I've been successfully building PDFs using XMetal since installing the CMS.

Has anyone seen the Build Failed dialog box (attached) or the errors (also attached) that I am seeing? Derek (or someone else on the JustSytems team) if you could look at the dialog box and the errors to tell me what might be wrong, I would much appreciate it. I have a doc deliverable in a week that depends on building a PDF with XMetaL.

Thanks,
Rick


* XMetalOutputFailed.png (28.83 KB, 650x176 - viewed 484 times.)

* XMetalErrorLog.png (87.75 KB, 810x795 - viewed 511 times.)
Logged
sudhira.tw@gmail.com
Member

Posts: 1


« Reply #1 on: January 15, 2013, 05:18:16 AM »

Hi,

I faced this problem as well. After integrating a specialization module, i tried to validate and generate output from a sample ditamap. Xmetal showed me the same error mentioned in this thread.

I tried to change the output location a couple of times. Once it generated the PDF and CHM with topics missing from it. At other instances it failed to generate the output.

Regards,
Sudhir
Logged
barbwire
Member

Posts: 44


« Reply #2 on: January 18, 2013, 01:45:17 AM »

Well, that image, which contains errror says it clearly:

SaxParseException: premature end of file

It basically means, that your xml file is empty or it has some kind of syntax error or your xml file does not exists. Try to make sure, that your xml file(s) are okay.

Especially ch or jp could bring some special characters, which MAY cause your problems.
Logged
Pages: 1
Print
Jump to:  

email us